Overnight stops between Arlington and Riverside

A 19 h 24 drive — sleep in Roswell and Show Low

1241.1 mi19 h 24 estimated2 night stops~4 fuel stopsestimated drive times

The 19 h 24 estimated drive between Arlington and Riverside covers 1241.1 mi and 4 states. This page plans it as a 3-day trip with 2 overnight stops — starting with Roswell and Show Low — using our seed drive model and town inventory. The hotel counts, detour minutes and arrival clocks on this page come out of the model run for these two endpoints specifically.

Quick answer

Plan on Roswell, New Mexico. At 7 h 17 from Arlington it lands close to the 6 h 28 first-night split our planner targets, and its 6-hotel seed count makes it the strongest sleep spot on this corridor. If it is full or you want a different pace, Albuquerque (9 h 27 from Arlington) or Alamogordo (8 h 31 from Arlington) are the next-best options.

Roswell has a smaller estimated hotel pool (about 6), so book ahead on weekends. The full plan below assumes an 8:00 am departure and 15 minutes of breaks for every 3 hours at the wheel.

Arrival, in plain numbers: leave Arlington at 8:00 am and the plan has you walking into a Roswell lobby around 3:47 pm local, with 12 h 15 left to Riverside the next morning. That leaves time for a real dinner — the estimated 6 hotels here sit in a town of 48,082, which usually means at least a couple of kitchens open past 8 pm.

We may earn a commission when you search Kayak through our links.

Hotels in Roswell — next Friday

The drive at a glance

This route summary is built from our v1 seed model, so treat every number as an estimate you confirm the day you drive. The corridor runs west-bearing from Arlington toward Riverside and the straight-line midpoint sits at 33.77, -107.17.

Route summary (estimated)Arlington to Riverside
Distance1241.1 mi of road (estimated)
Estimated driving time19 h 24 at the wheel
States crossed4 (estimated): Texas, New Mexico, Arizona, California
Overnight stops planned2 — Roswell, Show Low
Fuel stopsAbout 4 (1241.1 mi at roughly one stop per 350 mi)
Driving days3 days at 6 h 28 per day

You cross 2 time zones (Texas to California), so the local clock runs earlier by 2 hours as you travel.

In practice the rhythm of the trip is simple: 7 h 17 to the first bed in Roswell, a 5 h 10 hop to Show Low, and a final 6 h 57 push into Riverside. Nothing here is routed mileage yet — the seed model estimates road distance from geometry, so your odometer will read a few percent different by the end.

The corridor at a glance

ArlingtonRiverside1Roswell, NM2Show Low, AZ

Estimated corridor (straight-line path x road factor). Numbered markers are planned overnight stops: 1. Roswell, NM · 2. Show Low, AZ.

Primary stop: Roswell, New Mexico

FactRoswell, New Mexico
Population48,082 (seed estimate)
CountyChaves — county seat
Cumulative drive from Arlington7 h 17 (466.2 mi)
Remaining to Riverside12 h 15
Detour vs direct routeAbout 8 min
Estimated hotels6
Booking profileBook-ahead (fewer than 8 estimated hotels)

As the Chaves County seat, Roswell has a courthouse-square core with the restaurants and services county seats collect.

Why here and not somewhere else on the corridor: our solver scores every seed town near the day-split target of 6 h 28, and Roswell wins on the combination of an almost invisible detour, lodging depth (6 estimated hotels), and balance — you still have 12 h 15 to cover on the next driving day.

Shape the evening around the clock, not the odometer. You roll in near 3:47 pm local with 12 h 15 of driving ahead tomorrow, which is enough margin for a sit-down dinner and a full night — the plan deliberately avoids the 10 pm motel-door arrival that ruins day 2 of a 3-day drive.

The estimated 6 hotels here can sell out around local events, so lock a room before you pass the last easy exit. In the morning, an 8:00 am start from Roswell puts you in Riverside around 7:15 pm local on the final leg.

Alternate stop towns

Two more seed towns bracket the same stretch of the Arlington–Riverside corridor. They trade a little convenience for a different pace: an earlier exit shortens day one but lengthens day two, and the reverse is true past Roswell.

Alternates are not consolation prizes. A town 2 h 10 off the primary's pace can be the right call when a storm crosses the corridor or you simply want dinner in a different county — every card below carries the same numbers as the primary, so swap without re-planning.

Albuquerque, New Mexico

564,000 people, an estimated 28 hotels, 9 h 27 from Arlington — about 2 h 10 farther along. A book-any-night kind of town. Detour about 14 min.

Alamogordo, New Mexico

31,384 people, an estimated 6 hotels, 8 h 31 from Arlington — about 1 h 14 farther along. Book ahead here. Detour about 5 min.

Day-by-day plan (3 days)

Our split model targets equal driving days — 6 h 28 at the wheel each day — and the towns above land within minutes of those targets. Arrival times assume an 8:00 am departure, local time, plus a 15-minute break for every 3 hours of driving.

DayFromDepartToArrive (local, est.)DrivingMilesSleep
Day 1Arlington8:00 amRoswell, NM2:47 pm7 h 17466.2 miOvernight Roswell
Day 2Roswell8:00 amShow Low, AZ1:25 pm5 h 10330.3 miOvernight Show Low
Day 3Show Low8:00 amRiverside2:27 pm6 h 57444.6 miArrive Riverside

Arrival clocks use estimated local time (standard offsets). Crossing 2 time zones shifts the clock by 2 h; plan meals on driving time, not the dashboard clock. Total breaks across the trip: about 1 h 30.

The plan flexes in one direction easily: sliding departure to 7:00 am buys dinner options in every stop town — Roswell, Show Low — without changing any overnight. What does not flex is daily mileage — each day is already 6 h 28 of the 19 h 24 total, so adding a stop means dropping one of the towns above, not stretching the day.

Where to sleep, stop by stop

Lodging counts below are population-derived seed estimates, not live inventory. The book-any-night flag means 8 or more estimated hotels; anything less and you should reserve before your travel day.

Stop townEstimated hotelsBooking profileRates
Roswell, NM6Book-ahead
Show Low, AZ4Book-ahead

Two booking rules carry the whole table. First, match the town to your fatigue, not to the clock — pushing 30 min past Roswell to save a day usually means arriving at the far end wrecked. Second, on a 3-day drive the hotel is the only fixed cost you control on the road, so compare the Roswell rates above before you pass the last interstate exit for it.

Food and fuel, honestly

You will pass an estimated 4 fuel stops worth of distance (1241.1 mi at 350 mi per tank). The honest note: opening hours are not in the seed data yet, so gas-station coffee is a plan, not a promise — call ahead for anything you need after dark in Roswell.

Each planned stop clears a practical bar — an estimated 4 to 6 hotels across the corridor's sleep towns — but the v1 inventory does not tag amenities yet. Budget dinner before 9 pm or pack a cooler. The one number you can trust is distance: 1241.1 mi is 4 tank-sized chunks, and every planned stop town is big enough (population 12,038 and up) to hold the fuel and food a highway exit usually collects.

Timing, traffic and season

Leave at 8:00 am and you clear Arlington before midday traffic peaks, arriving at Roswell around 3:47 pm. This corridor crosses mountain states (New Mexico, Arizona), where winter storms and summer pass closures can add hours — check forecasts for the high country before you commit to a schedule. Summer heat is the main comfort variable; carry water for the warm stretches. At 19 h 24 total, this is a 3-day drive at a humane 6 h 28 per day.

Should you drive this at all?

At 19 h 24 of estimated driving this corridor sits outside the range where flying competes — the road is the plan, and the stop plan above is built for it.

Common questions

What is the halfway point between Arlington and Riverside?
By time, the halfway point is about 9 h 42 out of Arlington, near Socorro, New Mexico in our seed model. Our planned stop Roswell sits 2 h 25 from that mark.
Can you drive Arlington to Riverside in one day?
Not realistically. 19 h 24 at the wheel plus 1 h 30 of breaks runs past a 4:54 am arrival, so the 3-day plan with a night in Roswell is the honest schedule.
Where should you stop with kids?
Roswell is the anchor stop: an estimated 6 hotels, 12 h 15 still to go the next morning, and a 15-minute break built in every 3 hours. If you need an earlier exit, Albuquerque shaves the first day.
Is the Arlington to Riverside drive safe in winter?
The route touches mountain states (New Mexico, Arizona), so winter driving means chain laws, pass closures and short daylight. Check state DOT alerts before each day of the plan.
How many fuel stops does the drive need?
About 4. We plan one fuel stop per 350 miles, and the corridor covers 1241.1 mi, so fill up in Arlington, at the mid-corridor stops (Roswell, Show Low), and as needed before Riverside.

Search cars, hotels & flights

We may earn a commission when you search Kayak through our links.

Data & method

Method: v1 seed model. Drive times and distances come from straight-line geometry times a road factor, so every figure on this page is an estimate. Town facts come from a GeoNames-derived seed inventory; lodging counts are population-derived estimates. Overnight splits target equal driving days. We earn a commission from Kayak links.