Overnight stops between Allentown and Tampa

A 15 h 54 drive — sleep in Lumberton

1017.5 mi15 h 54 estimated1 night stop~3 fuel stopsestimated drive times

The 15 h 54 estimated drive between Allentown and Tampa covers 1017.5 mi and 8 states. This page plans it as a 2-day trip with 1 overnight stop — starting with Lumberton — using our seed drive model and town inventory. Every hotel count, detour minute and arrival clock below is computed for this corridor, not pasted from a template.

Quick answer

The best overnight is Lumberton, North Carolina — 7 h 42 from Allentown and 8 h 20 from Tampa, with an estimated 4 places to sleep and essentially no detour from the direct route. If it is full or you want a different pace, Dillon (8 h 04 from Allentown) or Conway (8 h 24 from Allentown) are the next-best options.

Lumberton has a smaller estimated hotel pool (about 4), so book ahead on weekends. The full plan below assumes an 8:00 am departure and 15 minutes of breaks for every 3 hours at the wheel.

Arrival, in plain numbers: leave Allentown at 8:00 am and the plan has you walking into a Lumberton lobby around 4:12 pm local, with 8 h 20 left to Tampa the next morning. That leaves time for a real dinner — the estimated 4 hotels here sit in a town of 19,451, which usually means at least a couple of kitchens open past 8 pm.

We may earn a commission when you search Kayak through our links.

Hotels in Lumberton — next Friday

The drive at a glance

This route summary is built from our v1 seed model, so treat every number as an estimate you confirm the day you drive. The corridor runs southwest-bearing from Allentown toward Tampa and the straight-line midpoint sits at 34.33, -79.24.

Route summary (estimated)Allentown to Tampa
Distance1017.5 mi of road (estimated)
Estimated driving time15 h 54 at the wheel
States crossed8 (estimated): Pennsylvania, Maryland, District of Columbia, Virginia, North Carolina, South Carolina, Georgia, Florida
Overnight stops planned1 — Lumberton
Fuel stopsAbout 3 (1017.5 mi at roughly one stop per 350 mi)
Driving days2 days at 7 h 57 per day

Both ends of this corridor keep the same clock, so your arrival math stays simple.

In practice the rhythm of the trip is simple: 7 h 42 to the first bed in Lumberton, and a final 8 h 12 push into Tampa. Nothing here is routed mileage yet — the seed model estimates road distance from geometry, so your odometer will read a few percent different by the end.

The corridor at a glance

AllentownTampa1Lumberton, NC

Estimated corridor (straight-line path x road factor). Numbered markers are planned overnight stops: 1. Lumberton, NC.

Primary stop: Lumberton, North Carolina

FactLumberton, North Carolina
Population19,451 (seed estimate)
CountyRobeson — county seat
Cumulative drive from Allentown7 h 42 (492.9 mi)
Remaining to Tampa8 h 20
Detour vs direct routeAbout 9 min
Estimated hotels4
Booking profileBook-ahead (fewer than 8 estimated hotels)

As the Robeson County seat, Lumberton has a courthouse-square core with the restaurants and services county seats collect. It sits about 31 mi from Fayetteville, North Carolina, if you want a bigger-city fallback.

Why here and not somewhere else on the corridor: our solver scores every seed town near the day-split target of 7 h 57, and Lumberton wins on the combination of an almost invisible detour, lodging depth (4 estimated hotels), and balance — you still have 8 h 20 to cover on the next driving day.

Shape the evening around the clock, not the odometer. You roll in near 4:12 pm local with 8 h 20 of driving ahead tomorrow, which is enough margin for a sit-down dinner and a full night — the plan deliberately avoids the 10 pm motel-door arrival that ruins day 2 of a 2-day drive.

The estimated 4 hotels here can sell out around local events, so lock a room before you pass the last easy exit. In the morning, an 8:00 am start from Lumberton puts you in Tampa around 4:50 pm local on the final leg.

Alternate stop towns

Two more seed towns bracket the same stretch of the Allentown–Tampa corridor. They trade a little convenience for a different pace: an earlier exit shortens day one but lengthens day two, and the reverse is true past Lumberton.

Alternates are not consolation prizes. A town 22 min off the primary's pace can be the right call when a storm crosses the corridor or you simply want dinner in a different county — every card below carries the same numbers as the primary, so swap without re-planning.

Dillon, South Carolina

6,516 people, an estimated 2 hotels, 8 h 04 from Allentown — close to the same stretch of road. Book ahead here. Detour about 18 min.

Conway, South Carolina

25,686 people, an estimated 6 hotels, 8 h 24 from Allentown — close to the same stretch of road. Book ahead here. Detour about 10 min.

Day-by-day plan (2 days)

Our split model targets equal driving days — 7 h 57 at the wheel each day — and the towns above land within minutes of those targets. Arrival times assume an 8:00 am departure, local time, plus a 15-minute break for every 3 hours of driving.

DayFromDepartToArrive (local, est.)DrivingMilesSleep
Day 1Allentown8:00 amLumberton, NC4:12 pm7 h 42492.9 miOvernight Lumberton
Day 2Lumberton8:00 amTampa4:42 pm8 h 12524.6 miArrive Tampa

Arrival clocks use estimated local time (standard offsets). This corridor stays in one time zone. Total breaks across the trip: about 1 h 15.

The plan flexes in one direction easily: sliding departure to 7:00 am buys dinner options in every stop town — Lumberton — without changing any overnight. What does not flex is daily mileage — each day is already 7 h 57 of the 15 h 54 total, so adding a stop means dropping one of the towns above, not stretching the day.

Where to sleep, stop by stop

Lodging counts below are population-derived seed estimates, not live inventory. The book-any-night flag means 8 or more estimated hotels; anything less and you should reserve before your travel day.

Stop townEstimated hotelsBooking profileRates
Lumberton, NC4Book-ahead

Two booking rules carry the whole table. First, match the town to your fatigue, not to the clock — pushing 30 min past Lumberton to save a day usually means arriving at the far end wrecked. Second, on a 2-day drive the hotel is the only fixed cost you control on the road, so compare the Lumberton rates above before you pass the last interstate exit for it.

Food and fuel, honestly

You will pass an estimated 3 fuel stops worth of distance (1017.5 mi at 350 mi per tank). The honest note: opening hours are not in the seed data yet, so gas-station coffee is a plan, not a promise — call ahead for anything you need after dark in Lumberton.

Each planned stop clears a practical bar — an estimated 4 to 4 hotels across the corridor's sleep towns — but the v1 inventory does not tag amenities yet. Budget dinner before 9 pm or pack a cooler. The one number you can trust is distance: 1017.5 mi is 3 tank-sized chunks, and every planned stop town is big enough (population 19,451 and up) to hold the fuel and food a highway exit usually collects.

Timing, traffic and season

An 8:00 am start puts the boring highway miles in the morning and the last hour into Lumberton in daylight — about 4:12 pm arrival on the plan above. Check the usual metro choke points at each end; everything between is steady cruising on this estimate. Summer heat is the main comfort variable; carry water for the warm stretches. At 15 h 54 total, this is a 2-day drive at a humane 7 h 57 per day.

Should you drive this at all?

Run the money before you commit 2 days to the road. Estimated fuel for the 1017.5 mi run is about $142.45 one way at $3.50/gal and 25 mpg, against a $280.00-per-person fare assumption. Break-even sits at 0.5 travelers: solo, the road costs about $137.55 less, while a party of four saves roughly $977.55 by driving — the trade is about 10.1 h of your time, since flying runs an estimated 5 h 48 door to door against 15 h 54 at the wheel. On those numbers the honest call for this corridor: drive.

Common questions

What is the halfway point between Allentown and Tampa?
By time, the halfway point is about 7 h 57 out of Allentown, near Dillon, South Carolina in our seed model. Our planned stop Lumberton sits 15 min from that mark.
Can you drive Allentown to Tampa in one day?
It is possible — 15 h 54 of driving plus about 1 h 15 of breaks is a 1:09 am arrival if you leave at 8:00 am — but the 1-stop plan is the safer version.
Where should you stop with kids?
Lumberton is the anchor stop: an estimated 4 hotels, 8 h 20 still to go the next morning, and a 15-minute break built in every 3 hours. If you need an earlier exit, Dillon shaves the first day.
Is the Allentown to Tampa drive safe in winter?
The corridor stays out of the high mountains, but 7 h 57 winter days still mean early darkness and storm windows — the 8:00 am departures in the plan above are built for that.
How many fuel stops does the drive need?
About 3. We plan one fuel stop per 350 miles, and the corridor covers 1017.5 mi, so fill up in Allentown, at the mid-corridor stop (Lumberton), and as needed before Tampa.

Search cars, hotels & flights

We may earn a commission when you search Kayak through our links.

Data & method

Method: v1 seed model. Drive times and distances come from straight-line geometry times a road factor, so every figure on this page is an estimate. Town facts come from a GeoNames-derived seed inventory; lodging counts are population-derived estimates. Overnight splits target equal driving days. We earn a commission from Kayak links.